Additional information
PLA | DSS |
---|---|
Brand | Dominion Sure Seal |
Colour | Clear |
SIZE | 5 L / 1.32 gal |
echo "
$80.19
This 2:1 low VOC Clearcoat is formulated to produce a finish that will compare with any clear coat available on the market today.
SURFACE PREPARATION:
1. Mask all areas that you do not want coated.
2. Clean the surface to be coated with a good quality wax & grease remover
3. Sand cured paint or OEM finish with 800 grit sand paper. Make sure you de-gloss the surface.
4. Re-clean the surface with a good quality wax & grease remover.
RECOMMENDED SUBSTRATES:
• All basecoat systems
• Polyurethane enamel (after 8 hour dry)
• Acrylic urethane enamel (after 8 hour dry)
• Gel coat (must be properly prepared)
MIXING DIRECTIONS:
Mix 2 parts EU121 Clearcoat to 1 part Activator by volume.
(Note: Addition of Reducer up to 1 part by volume is optional and will increase VOC).
APPLICATION:
1. Apply basecoat color per manufacturer’s recommended procedures. Note: Allow polyurethane and acrylic enamel basecoat to dry at least 8 hours before applying clear.
2. Apply two wet coats of clear using 50-60 psi at the gun for conventional spray or 6-10 psi at the gun for HVLP.
3. Mix EU121 with appropriate activator for conditions as per above instructions.
4. Allow 10-15 minutes flash between coats. Optional: On small jobs (i.e. fenders & doors) one tack coat can be applied, followed by one full wet coat with no flash between coats. Tack coat must be applied evenly.
BUFFABILITY:
EU121 clear coat can be wet sanded and buffed between 8-12 hours. EU121 should be buffed within 36 hours for best results. Film thickness, flash times, and temperature will effect buffing times.
PLA | DSS |
---|---|
Brand | Dominion Sure Seal |
Colour | Clear |
SIZE | 5 L / 1.32 gal |